CRF250L-tyre_wheel

Sprocket   -編集中-

CRF250Lのスプロケ交換は良く聞くのだ。

だけど、スプロケ交換するとスピードメーターの表示が狂う。

そのため、スプロケ交換による表示速度と実速度の計算を頭で行う必要がある。

 

* * *や 、 そ ん な こ と を し な く て も 良 い の だ 。 * * *
(どや)
http://shop.12oclocklabs.com/

12 oClock Labs のSpeedo DRDで解決するのだ。

http://www.youtube.com/watch?v=10ziF5-jIaY
この動画でセットアップが説明されている。

 

マニュアルを抜粋して説明するぜ。

3種類の内、好きな計算方法でコレクションレシオを導くんだ。折角だから、俺は赤のスプロケを選ぶぜ!

Using your modified gearing the formula is:
Correction Ratio =((your front sprocket / your rear sprocket) / (factory front sprocket / factory rear sprocket) * 100)– 100
スプロケで計算方法。コレクションレシオ= (   (交換したFスプロケ/交換したRスプロケ)  /  (純正Fスプロケ/純正Rスプロケ) x100) -100

ok,guys.まず最初に 交換したFスプロケRスプロケで割るのだ。それを「χ」とするぜ。 次に純正Fスプロケ純正Rスプロケで割るのだ。それが「」だぜ。
χyで割るんだ。その後 100を掛けるぜ。 その値から100引くんだ。 OK,それがコレクションレシオだ。覚えておけよ。

 

Using the Speed of a GPS device the formula is:
Correction Ratio = ((GPS Speed / Speedometer Readout) * 100) – 100
     GPS(ナビなど)上スピード/ メーター読みスピード

 
Using the Distance from a GPS device the formula is:
Correction Ratio = ((GPS Distance / Odometer Distance) * 100) – 100
         GPS(ナビなど)上の距離/ ODOメーター距離
 
 

上二つは細かい説明は飛ばすぜ? exampleに例書いてるぜ。
 

Example:
Lets say your GPS reads 55mph but your Speedometeron your vehicle reads 60mph,you would do the following math:
GPSで55マイルで進んでるとき、メーター読み60マイルだとするぜ? そのときの計算方法だ。

((55 / 60) * 100) – 100 = -8.3 (round to one decimal place) [Your correction ratio would be -8.3%]
((GPSで55マイル/メーター読み60マイル) x100) -100 ってことだぜ。答えは[-8.3]だから、コレクションレシオは -8.3%だぜ!
 
 
 

How to Setup the SpeedoDRD
セットアップするぜ?

 
1)
Turn ON the vehicle (don’t start it), the unit will quickly flash RED then GREEN, now HOLD the button until the LED turns ORANGE,then quickly release.
キーをONにするぜ。でもセルを回さないんだぜ。そうしたらの順番でLEDが点滅するんだ。そうしたら、LEDがオレンジになるまでボタンを押し続けて、その後、すぐに離すんだ。
 
You are now in setup mode, you are now seeing a quick red and green flashing pattern,this pattern is called the Alt Pattern, it signifies the unit is readyfor you to input somedata.
これでセットアップモードになったぜ。LEDがと点滅するパターンを見るんだ。このパターンはAltキーパターンだぜ。これはデータ入力準備OKって意味だぜ。
 
2)

First Data we input is the Conversion Mode, HOLD the button down, the LED will change from GREEN [MPHto KPH], toRED [KPH to MPH],to ORANGE [No Conversion].
コンバージョンモードは、ボタンを押したままLEDが緑色[MPH → KPH(マイルからキロ)]、[KPHMPH(キロからマイル)]オレンジ[変更なし]に変更される。

Release the button at the color which represents the conversion modeyou would like to select.
それぞれ使いたいモードの色の時にボタンを離すんだ。つまり、マイルからキロに変換したい場合はでボタンを離すんだぜ。

ORANGE [No Conversion] isthe most common selection for all users, it is very rare you wouldever want to select anything else.
オレンジ(変更なし)は超一般的な状態だぜ。普通はオレンジの時にボタンを離せば良いんだ。つまり、このコンバージョンモード特別な時以外、オレンジ以外でボタンを離さなくて良いんだぜ・・・。

 
3)
You will now see the Alt Pattern again, HOLD the button down, the LED will change from GREEN [positive], to RED[negative].
次だ、再度、Altキーパターンの時にボタンを押したままにすると、LEDは[マイナス]、[プラス]に変わるぜ。
 
Release the button at RED for a negative correction ratio, or GREEN for a positive correction ratio.
プラス・マイナスに設定するときは、LEDがそれぞれ[マイナス]、[プラス]の時ボタンを離すんだ。
 
4)
You will now see the Alt Pattern again, you are now going to enter the first digit of your 3 digit correction ratio number,
その後だ、Altキーパターンが表示した後、最初に計算した3桁のコレクションレシオ最初の桁(上桁)から入力(ボタンを押した後、点滅をカウントしてボタンを離す)するんだ。
 
this is the 10’s column [X]X.X , HOLD the button, and count the blinks, 10 blinks represents a zero.
いいか。レシオが「56.7」 なら5の部分だ。ボタンを押し続けて点滅回数を数えるんだ。ゼロは10回点滅すればokだ。
 
 
5)
Repeat the same method again for the next two numbers, remember the last number is your decimal pointnumber, ifyou don’t have a decimal pointin your correction ratio, the last number should be zero.
一桁目が入力し終わったら、残りの2桁を同じ要領で入力するんだ。 いいか、最後の桁は小数点だぜ。
 
6)
After entering the last digit, the Setup will be blinked back you to; example:
最後の数字を入力したら、LEDがと点滅するぜセットアップモードに戻ったって意味だ。
 
1 ORANGE blink, 1sec pause, 5 red blinks, 1sec pause, 1 LONG red blink. = No Conversions -5.0%
オレンジ1点滅、1秒消灯、5点滅、1秒消灯、長い1点滅。= ノーマル状態から -5.0% ってわけさ。
 
Note: The last number blinked is always the decimalpoint number. A zero will be a long blink. Any leading zero’s in acorrection ratio numberwill be omitted when the number is blinked back to you.
注:しつこいけど、最後の数字は小数点だぜ。ゼロが長い点滅だぜ。コレクションレシオの最上桁がゼロの場合はセットアップモードの時は最上桁のゼロは点滅しないぜ。

 

CRF250L 参考配線
http://www.youtube.com/watch?v=YU1Tl_-Fong

 

 

 

TYRE

 

 

 

WHEEL

最終更新:2013年06月13日 00:57